Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: Correct Alternator wiring connection..

Correct Alternator wiring connection.. 12 Aug 2017 10:45 #1

  • ozbucko
  • ozbucko's Avatar Topic Author
  • Offline
  • Senior Member
  • Senior Member
  • Posts: 172
  • Thank you received: 14
Refitting the new alternators I am at a small dilemma.
The wiring leading to the back end on my engine wiring harness has 2x8 mm ring connectors and the standard 2 pin .

On both the old and new alternators there is a P that accepts a spade connector.
As I was not the person who removed the wiring from the alternators I am unsure if one of the positive leads should be attached to the power post on the alternator and the other much smaller wire changed to a spade type or bolt the two to the main pole of the alternator.
If you look at the pics it shows the main pole, the 2 pin connector, and the spade with P over it.
My question is connect the 2 reds to the main pole and the 2 pin and forget the spade connector, or split the smaller power wire add a spade connector and connect to the area where the P is?

This message has attachments images.
Please log in or register to see it.

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Moderators: Jim GandeeRuffryder
Time to create page: 0.072 seconds
Powered by Kunena Forum